Car Stop Light Switches

Stop and take a good look at your factory Stop Light Switch if your brake lights have stopped working. There's a good chance the switch is the culprit if there seems to be nothing wrong with the fuse and the bulbs. As you may know, the switch is typically located under the dash. It's responsible for allowing current to flow and activate the brake lights whenever you depress the brake pedal. It serves a crucial function in your vehicle as without it operating normally, your lights may only turn on intermittently or may not come on at all, drastically increasing your risk of collision on the road. Without brake lights on, other drivers won't be able to judge your distance.

Stop Light Switches, especially factory ones, are known to fail over time. The most common symptom is the lights' intermittent operation or complete failure. There are also drivers who experience other symptoms related to the design of their vehicles. For instance, depending on your vehicle, it's possible for your automatic transmission to get locked out if your switch is shot. There are other possible reasons why the switch may just suddenly stopped working. For example, defect on the switch's connectors and wiring usually results in brake lights refusing to come on.

The simplest way to check whether your Car Stop Light Switch is shot or not is by having someone observe the brake lights while you run your vehicle at idle speed. Tell the person to take note whether the lights will come on as you step on the brake pedal. If the lights don't turn on, it's very likely that the switch is busted. But if the lights do turn on though delayed, you probably only need to make some adjustments to the switch to correct its timing. The typical way to do this is by turning the switch's adjusting nut while you're pressing the brake pedal, which would allow you to either quicken or delay the switch's timing.

Once you confirm that the Stop Light Switch is shot, don't bother tinkering with it and replace it right away. You'll never run out of great options for replacement parts as there's almost an endless array of heavy-duty aftermarket switches to choose from. Installing one of these high-quality switches is easy. Just locate your old switch near the brake pedal lever and pull back its trim 'til you see the switch, which typically comes in the form of a module with two steel prongs. Carefully connect the new one to the wiring and your brake lights are ready to go.

Driving without a working Stop Light Switch is like driving invisibly on the road. You'll be a collision magnet in no time if you attempt to do it. Fix your car as soon as possible by checking out our extensive catalog of top-notch aftermarket switches here at Parts Train. Your safety depends on it, so go ahead and look for a switch that matches your specs now.
.